Trapshooters Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
All steel PULL Timney Trigger for trap (no safety). Full Timney Assembly. Clean with crisp edges. Works Good. $200 with free shipping to lower 48 states. Mike Dirksen - Valley of the Moon Trap Club - Sonoma, CA.

 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
There is no tape or metal on the trigger assembly.
The rough grainy area indicated by the white arrow is where a sharp edge that hit fat trigger fingers was ground off. Mike Dirksen - vomtc.org
 

·
Registered
Joined
·
13,608 Posts
I'm what I'm referring to is what I outlined and arrowed here. Appears to be something attached to the trigger, with a lift up on the bottom edge, LH side, about 1/4" in.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
Here are two detail photos of the area you are concerned about.
Everything is just as Timney made it, except for the files off edge at the point of the white arrow.
 
1 - 6 of 6 Posts
Top