Trapshooters Forum banner

Status
Not open for further replies.
1 - 10 of 10 Posts

·
Banned
Joined
·
63 Posts
Discussion Starter #1
Stainless BT99 34" invector plus chokes, trigger and forcing cones done by Briley Manf, trigger is exactly 3 1/2 lbs with no creep, gun is very tight hasnt been shot much, the guy that bought it new, just bought it to have it, been setting in his gun safe, lop 14 1/2 with a 1" kickeze pad has the graycoil recoil pad adjuster on the back, gun is at least 95% a few small handeling marks asking 1350.00 or best "reasonable offer" THANKS Larry
 

·
Registered
Joined
·
1,173 Posts
Boy! I would love to have this gun! Unfortunately my finances just won't allow it at this time, but I bet it doesn't last long! Jack Farrow
 

·
Banned
Joined
·
10,106 Posts
Ain't never seen a Stainless BT-99 with a laminated stock. Show us a picture of the barrel where it says "Stainless" and call me a liar!!
 

·
Registered
Joined
·
3,002 Posts
FWIW, it's a 2007 Shot Show Special- Grey Laminate Nickle. It was never in the 2007 catalog, ordered only at the Shot Show. Last I heard there was 5000 to 5500 made.

Wayne
 

·
Registered
Joined
·
340 Posts
Nickle finish - does that mean it's steel that is coated with nickle? or is the surface really steel, but the finish looks like nickle(nickel)?
 

·
Registered
Joined
·
1,173 Posts
I wish a couple of the good dealers, like Merlyn or Schultz would weigh in on this. I think I saw one that looked just like this at the Missouri Fall Handicap that was marked "stainless". But, I could me mistaken. Jack
 

·
Well-Known Member
Joined
·
5,366 Posts
matte nickel finish... SHOT Show special... I have one as a guest gun. There have been a few posts on this and other sites which put production at less than 500 pcs.

Jay
 
1 - 10 of 10 Posts
Status
Not open for further replies.
Top