Trapshooters Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Premium Member
Joined
·
2,940 Posts
Discussion Starter · #1 ·
It's hard to not like a pretty gun! Here is a (41XXX) MX-8 reciever mated to a 2001 vintage MX-8 ramp rib barrel and stocked with some really nice English walnut. The RAD system will allow for adjustment from 14.25 to 15+ inches of LOP. The triggers have Allems's releases (which are easy to remove...) and the trigger is adjustable. The bores on both tubes measure .740 and the chokes are .017 bottom (LM)and .027 top (IM). Set up for trap doubles.

The Baroque pattern deep chisel engraving was done by Bill Mains a couple of years ago.

Price $10,500.00 Trades considered. PM, email or Phone (800-684-6329)

Thank you for looking! Bob Schultz


bobschultz_2008_0303103.jpg


bobschultz_2008_0303104.jpg


bobschultz_2008_0303105.jpg


bobschultz_2008_0303106.jpg


bobschultz_2008_0303107.jpg


bobschultz_2008_0303108.jpg


bobschultz_2008_0303109.jpg


bobschultz_2008_0303110.jpg


bobschultz_2008_0303111.jpg

 

·
Premium Member
Joined
·
2,940 Posts
Discussion Starter · #4 ·
*** F/S Perazzi MX-8 ENGRAVED! 32

Since someone emailed me and asked...I laser tested both barrels and they shoot to the same POI. As it sits, with the beads stacked, it shoots 65/35.

Thanks,

Bob
 

·
Premium Member
Joined
·
2,940 Posts
Discussion Starter · #5 ·
*** F/S Perazzi MX-8 ENGRAVED! 32

The Allem's releases are the standard variety not the roller release. Thanks for your emails!

Bob
 

·
Premium Member
Joined
·
2,940 Posts
Discussion Starter · #6 ·
*** F/S Perazzi MX-8 ENGRAVED! 32

With a set of Briley Choke tubes this would make a great Sporter!!

Bob
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top