Trapshooters Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
For sale, 28 gauge MEC 650 single stage reloader. The reloader is about 18 months old. I got a different press at a good deal and got a 28 gauge
conversion for it. I need to get $180.00 for it and shipping. For additional
information contact me at [email protected]
Located in Pa.
 

·
Registered
Joined
·
883 Posts
Yes. And you can nicely resize the shell on the press at the 1st station if you have the proper insert & parts. But it is a seperate operation. You resize all the hulls,remove the insert/parts & then procede to load as a progressive. All the 650's are this way,at least the newer ones.
 

·
Registered
Joined
·
4,614 Posts
Why on earth anybody would go through all that is beyond me. Just buy a grabber. Jeff
 

·
Registered
Joined
·
883 Posts
It has been my experience that the Grabber style does tend to jiggle the the smaller shells quite a bit,esp the .410. This can spill shot. Also the extra parts that work the sizer op on the Grabber can get out of time & cause trouble. Less of a problem on the 12 & 20. I use the 650 in 28 & .410,sizing with a seperate super sizer if needed. I have loaded with MEC's for about 43 yrs. I have 6 & my son has 4. My Hustler is prob 35 yo & runnin' great. We both have all older models.
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top