Trapshooters Forum banner

1 - 17 of 17 Posts

·
Premium Member
Joined
·
2,942 Posts
Discussion Starter · #1 ·
Is there anyone out there who makes a tapered add on delrin rib or aluminum rib for Perazzi shotguns?

Thanks for your help.

Bob Schultz - Target Shotguns Inc.
 

·
Premium Member
Joined
·
11,895 Posts

·
Registered
Joined
·
418 Posts
What is the weight difference between delrin & aluminum?
Aluminum weighs .097 to .102 lbs/cubic inch, depending on alloy.

Delrin weighs .049 to .058 lbs/cubic inch, depending on composition.

So, aluminum is roughly twice the weight of Delrin for a given volume. ....However, aluminum is greater in strength.
 

·
Registered
Joined
·
4,763 Posts
A guy at our club made a wooden one for his TM-1. He said it was a mock-up to get the height right. He does well with it, I told him to call Joe at add a rib when he's ready to make it permanent.
 

·
Registered
Joined
·
2 Posts
I can taper them for point of impact and also for width. I custom make them to fit over the existing rib and then step them down to be the same width as the existing rib.

Dave Berlet
Dave are you still making Delrin Ribs? I’d like to discuss you making one for my K-80 if you do. Thanks
 
1 - 17 of 17 Posts
Top