Trapshooters Forum banner
1 - 20 of 42 Posts

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #1 · (Edited)
I have 3 bars left. One can be machined for MEC powder bushings. If you want one send me an email or a PM.


Rectangle Wood Audio equipment Hardwood Wood stain

Rectangle Material property Gas Electric blue Circle


Here is a close up showing the finish I put on the top and bottom of the bar. The surface finish is what improves the seal efficiency reducing leakage.
Green Baize Rectangle Azure Grey


Preliminary testing shows the Delrin bar runs smoother and eliminates the wear between the bottom of the bar and the housing. Preliminary evaluations indicate it improves sealing with the finer powders like Hodgdon H110.

The Delrin bar is $90.00 plus $8.95 shipping.

1757777


Here are some examples of wear on the OEM aluminum charge bars.
Red Games Table Wood Furniture
Bumper Rim
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #3 ·
Do you mean the Patriot? The 800 series does not have a charge bar.
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #7 · (Edited)
The Delrin bar is $90.00 plus $8.50 shipping.
 
  • Like
Reactions: CCTiger

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #8 ·
BUMP 7/7/2021
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #9 ·
UP
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #10 ·
Up
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #11 ·
BUMP for price increase to $90 due to increased material cost.
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #12 ·
UP
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #13 ·
I will have Delrin bars ready by the end of next week (February 25, 2022). Send me an email or PM if you want one.

Jim Skeel
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #14 ·
Delrin charge bars are ready.
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #16 ·
Jim,
Any thoughts of making these to fit MEC powder bushings without have to use an adapter?
That is an interesting idea. I will give it some thought.
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #17 ·
Jim,
Any thoughts of making these to fit MEC powder bushings without have to use an adapter?
I can do that. I just had to check to be sure I had the necessary tooling. It would be a special order item, meaning you pay me and then I make the bar.
 
  • Like
Reactions: Charlie Becknell

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #19 ·
BUMP
 

·
Supporting Vendor
Joined
·
6,207 Posts
Discussion Starter · #20 ·
UP
 
1 - 20 of 42 Posts
Top