Trapshooters Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
279 Posts
Discussion Starter · #1 ·
Anyone ever done this? I'm thinking of using a dremel tool to enlarge the top slot and use some sort of epoxy on the lower side of the grip. Not sure about how to get the fit right where the rear of the receiver (where stock screw hole is) mates with the grip.

Got any tips?
What epoxy should I use?

In case I chicken out, anyone know any professionals who might do this and what they might charge?
 
1 - 2 of 2 Posts
Top