Trapshooters Forum banner

Status
Not open for further replies.
1 - 9 of 9 Posts

·
Registered
Joined
·
2,194 Posts
Discussion Starter #1
Anyone use these? I assume that it is the 1 oz version of the windjammer. Used in a STS or AA hull. Any thoughts or experience with them?

Thanks
WesleyB
 

·
Registered
Joined
·
10,302 Posts
They are a VERY tall wad that works well with 7/8 and 3/4 oz loads. I have had best luck with them in compression formed hulls.

They don't go in a press like some other wads, but are priced right and give good results.
 

·
Registered
Joined
·
2,194 Posts
Discussion Starter #4
Is Federal straight wall?? And STS is Tapered? Says it suppose to fit both. How can that be?
 

·
Registered
Joined
·
10 Posts
I am using 4100-12-B with AA hulls and 17.8 grains of Accurite Nitro 100. I am loading these with 7/8 oz shot. Pushing around 1300 fps. They work fine, crimp well and load easy in my PW 800.

Jon Jacobs
 

·
Registered
Joined
·
2,194 Posts
Discussion Starter #7
Thank you also Jon. I am looking at 17.3 grains of SOLO 1000 with this wad with 1oz of shot. But i might just try the 7/8 oz.

Thanks
WesleyB
 

·
Registered
Joined
·
1,258 Posts
This is my wad of choice for 16 yd, 1st shot of doubles, skeet, and all "close" shooting. 7/8oz of 8 1/2s or 9s, pushed by 16.5gr Nitro100 or 17.5gr E3 in A-A hulls definitely gets the job done. Tough to beat !

AndyH
 
1 - 9 of 9 Posts
Status
Not open for further replies.
Top