[Pull-it!]

I am trying to understand the adjustments on my Citori Plus Adj. rib. I have read thru the instructions and let them confuse me! The present set up is the pin is in the hole closest to the end of the barrel, and the back rib adjustment is about in the middle. The pattern at 3o yds is about a 90/10 or 85/15. Poi at 13 yds shows the biggets consentration of shot going thru paper at about 3-1/2" above hold pont. Would love to go back to about 80/20 or 70/30.

 

[Beretta Young Gun]

drop the back of the rib all the way down....take the gun out and pattern it....raise the back of the rib in small incriments until you acheive the POI that you want. BYG

 

[1 oz]

Try lowering the back of the rib to the bottom. Then adjust the comb down till you get the poi you want. Then just adjust the back of the rib up till you get the bead confiugration you looking for.

Jeremy

 

[RLC323]

Which barrel are you setting POI for? The bottom barrel on my Plus shoots a bit higher than the top barrel.

Adjust the comb down, keep the front of the rib in the up position. Rear screw all the way down. This should make it shoot near flat. Raise the comb, and rear of rib in sync to gain height in your POI.