Trapshooters Forum banner

1 - 7 of 7 Posts

·
Premium Member
Joined
·
671 Posts
Discussion Starter #1
Could someone help me to identify the maker and constriction of the choke below. It has a marking “8” on the edge of choke. The overall length is about 1 3/4” (the angle of photo is a bit distorted). It came with a Perazzi TM1 bought here. Thanks.

 

·
Premium Member
Joined
·
671 Posts
Discussion Starter #6
Thank you call for the info. I later found during cleaning that this is a TMS, not TM1. So it makes sense that it has a factory choke.
 

·
Registered
Joined
·
533 Posts
Early guns with generation 1 choke tubes were called TMS' for some reason. I owned one once for a back up gun for my TM1 It was from the short run of Winchester imported guns before Perazzi USA.
 
1 - 7 of 7 Posts
Top