Trapshooters Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
259 Posts
Discussion Starter · #1 ·
Moved last year and it the process I mislaid my Chamber Mates extraction tool. Willing to buy the tool as part of a set....mine is 16 ga - 28 ga but I suspect any would meet my need.
V/r
Maxey
 

·
Registered
Joined
·
259 Posts
Discussion Starter · #2 ·
Or if you are in the San Antonio area and could meet at the SAGC and let me borrow one for a few minutes!
V/r
Maxey
 

·
Premium Member
Joined
·
12,893 Posts
All the tool is is a pistol cleaning rod with a screw threaded into the end - a small brass washer gives it a lip that lets it hook on the forward edge of the ChamberMate.

If you have the cleaning rod all you need is the correct screw and a washer.
 

·
Registered
Joined
·
691 Posts
Hello: It uses a 8-32 brass screw and brass washer. I bought mine from Ace Hardware. I think the brass cleaning rod is a Lyman one that is about 8-10" long. Thanks, Eric
 

·
Registered
Joined
·
3,305 Posts
LOL,,, Really ??????? the one that came with my used set is exactly as you describe . I thought it was a home made replacement for a lost factory one.....
 
1 - 7 of 7 Posts
Top