Trapshooters Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
1,069 Posts
Discussion Starter #1
Looking to trade the mid high rib on my Summit for the "High" Rib
34" Barrel
thanx
Mike
 

·
Registered
Joined
·
1,962 Posts
So your aware of what you are asking for,
CG 34” unsingle Trap - high rib (25mm )
CG 34” unsingle Impact - mid high rib (17 mm)

2 completely different guns.

I believe this swap would require a complete gun swap because the rib/stock configuration is built into the gun. Putting Impact Barrels on a Trap stocked action would not allow you to ever get the comb low enough. And the opposite goes with putting Trap rib barrels on an Impact stocked action would require the comb to be raised up possible beyond the limitations of the comb hardware.

Good luck with your goals, Ken
 

·
Registered
Joined
·
1,069 Posts
Discussion Starter #4
So your aware of what you are asking for,
CG 34” unsingle Trap - high rib (25mm )
CG 34” unsingle Impact - mid high rib (17 mm)

2 completely different guns.

I believe this swap would require a complete gun swap because the rib/stock configuration is built into the gun. Putting Impact Barrels on a Trap stocked action would not allow you to ever get the comb low enough. And the opposite goes with putting Trap rib barrels on an Impact stocked action would require the comb to be raised up possible beyond the limitations of the comb hardware.

Good luck with your goals, Ken
Thanx!
My ignorance shines through!!
Mike
 

·
Registered
Joined
·
2,221 Posts
I will call bullshit on you can’t tell a difference in the 1/4” . The difference is the higher rib will shoot a higher point of impact if you need it to.

Also you guys are correct. The ribs are not interchangeable.
 
1 - 9 of 9 Posts
Top