Trapshooters Forum banner

Canterbury replacement Speakers

5844 Views 19 Replies 15 Participants Last post by  ric3677
I know this has been gone over before but since we lost all the past data in the crash, I have to resort to asking again.

We have the metal ones that come with the original wired Canterbury's. With time they have gotten beat up and some are not working properly.

Can anyone tell me where to turn? We have tested all of ours and DB rates are located together which results in better working voice calls. Are the replacement speakers going to work with ours and vice-versa.

I hope this all makes sense to someone.

thanks in advance.......Rickyd
Status
Not open for further replies.
1 - 1 of 1 Posts

· Registered
Joined
·
457 Posts
Hi,

I have found lots of bad wire but even beat up speakers still work.

Measure with an O-Scope, should be around 50 MV or in that area. That is all you need.

All that can happen for the most part is the speaker will be an open, which is bad or almost a short which is normal.

Take care,

Jim
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top