Trapshooters Forum banner

Can you Identify what these choke tube fit?

837 Views 5 Replies 5 Participants Last post by  Dustydoo
I have a set of choke tubes and do not know what kind of gun they fit. They are .824 exterior diameter and 1.96 inches tall (to slight edge just below knurling) and have 32 TPI threads. They are marked according to choke, but not to type. They are very close to a Browning Invector Plus (2.38" diameter ) but are shorter. Let me know if you have any ideas.

Household hardware Cylinder Nickel Auto part Metal
1 - 6 of 6 Posts

· Registered
260 Posts
Discussion Starter · #5 ·
Guys, thanks for the replys. I screwed the choke tube into an invector plus barrel and it went in past the knurling and was not yet seated so I stopped at that point. It will not fit into a Rem-choke barrel or a invector (win-choke) barrel.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.