[Charlie Becknell]

Are PW and Hornady powder/shot bushings interchangable?

 

[Rick Barker]

Yes, so are some of the discontinued brands like Pacific, just make sure you do not put them upside down.

 

[TXGREG]

Yes. There is also an adapter made that will allow you to use MEC bushings on PW and Hornaday loaders.

 

[HSLDS]

Not mine in the original, but posted here by several members...

 

[Nebs]

^^I interpreted the OP's question as asking whether the outside diameters of the bushings for each of the 2 brands of loader are the same such that one would fit in the other. The answer is "yes." I think everyone also knows the two brands use different numbering systems and there is no way to correspond one to the other..

 

[HSLDS]

...there is no way to correspond one to the other..

The charts I posted above should include a decent cross referencing section.

Again, not my work. I think a good bit comes from Whiz White at S/W Supply, but others contributed as well.

 

[Charlie Becknell]

I have a Spolar, and a PW that I inherited. Just wanted to see if those bushing fit

 

[pheasantmaster]

I have a Spolar, and a PW that I inherited. Just wanted to see if those bushing fit

While they'll fit, I would advise you to not use the steel PW bushings in the Spolar charge bar. You can use any Hornady, RCBS, or Spolar (Hornady) bushings in your Spolar but PW should only be used iny PW.

 

[ernscott]

It would be easy enough to mic. the heights and diameters to be completely sure. You for sure would not want them to be too tall or short. Regards ES