Trapshooters Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
3,458 Posts
Discussion Starter · #1 ·
I use a bump buster on one of my clay guns & it's fairly easy to remove the set screw that holds the unit in the stock, remove the unit, loosen the little lock on the dial & then set the tension. However, I would call Ken Rucker (903-815-6535) & have him send you a diagram so as not to do any damage to the unit as you work on it. If you would PM me with your email address I can scan a copy of mine & send it to you.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top