Trapshooters Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have a Browning BT100. After firing the shell did not eject so I dropped the trigger assembly out to change the setting so it would. Come to find there was no screw driver slot to make the adjustment, just a solid steel plate. Does anyone know if the assembly can be modified to have the selector? Where is a good place to have it done? Or, do I have to find another trigger group? Does such a part have to be gotten from Browning or are there other places to get them? I looked online at Brownell's but was unsuccessful. Thanks.
Mike
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top