Trapshooters Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
13,991 Posts
Discussion Starter · #1 ·
Original poster deleted post. Below was my response to his initial posting:

Most likely not for a K80 (at least not a stock one), since their nominal bore is around .732. These look like they were possibly built for a carrier barrel based on your measurement on the center boss of close to .750". The only production gun that I'm aware of with a .750 bore would be Kolar, which I highly doubt they were made for, so they probably fit a barrel that was either backbored aftermarket, or turned into a carrier barrel when the tubes were fit...
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top