Trapshooters Forum banner
Status
Not open for further replies.
1 - 10 of 10 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Does anyone have recommendations from first hand experience, of someone to rebuild my Beretta combo. Full service, action tightening, fore end tightening, new firing pins and springs. I know Coles are supposed to be the Beretta experts, but have heard they are relatively expensive.
 

·
Registered
Joined
·
137 Posts
Hello Claybuster,

I sent my 687 combo to Midwest gun works located in Pevely, MO for the same work
you describe, I am very satisfied with the results & the price. Pull up their web page , they have services listed.
 

·
Premium Member
Joined
·
13,736 Posts
Coles is in Harpswell, Maine.

As good as it gets - they have pretty much all parts in stock as well, and no too far from you.
 

·
Registered
Joined
·
850 Posts
Couple friends, while at the grand, had Beretta go through their 682s. I was impressed with the service time (couple hours or less) and the price. In fact Beretta inspected one gun, found nothing wrong at no charge to owner. Cannot beat that.
 

·
Registered
Joined
·
1,478 Posts
Just Go to Beretta Service center.
http://www.berettausa.com/service/find_a_service_center.aspx

Gunsmithing, LTD.
2530 Post Road
#3 Lacey Place
Southport, CT 06890
Region Served: Northeastern United States Phone: (203) 254 0436
Fax: (203) 254 1535

I use Mitch at Gunsmithing LTD. I can tell you first hand he the best
with good price's
The Beretta Gallery in NYC use Mitch at Gunsmithing LTD
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top