Trapshooters Forum banner

Status
Not open for further replies.
1 - 11 of 11 Posts

·
Registered
Joined
·
1,453 Posts
Discussion Starter #1
I have the parts that is needed to change your Pull Pull Triggers on a 682 to Double Release Parts were made By Phillip's Gunsmitting, looking for serious offers for these parts, if you are a handy person you can probaly install them your self, only takes Me about 1/2 hour to switch them out and I am not a gunsmith...
<a href="http://photobucket.com" target="_blank">
</a>
<a href="http://photobucket.com" target="_blank">
</a>
<a href="http://photobucket.com" target="_blank">
</a>
<a href="http://photobucket.com" target="_blank">
</a>
<a href="http://photobucket.com" target="_blank">
</a>
<a href="http://photobucket.com" target="_blank">
</a>
 

·
Registered
Joined
·
385 Posts
Will that 682 set-up work in a 686 or are they not interchangeable? THANKS...BUD
 

·
Registered
Joined
·
46 Posts
I have a 682 Gold E Unsingle combo. Will the Selectable barrel function still work?? Also can only 1 hook be used to make Release / pull setup Thanks Larry
 

·
Registered
Joined
·
1,453 Posts
Discussion Starter #11
"""Sale pending"""" And in answer to the two above post yes on the 686 no on the release pull ( A double release is one single hook theat holds back both hammers, but probaly can be cut to miss the second hammer ) But I would check this out with phillip the trigger Man......
 
1 - 11 of 11 Posts
Status
Not open for further replies.
Top