Trapshooters Forum banner

Status
Not open for further replies.
1 - 9 of 9 Posts

·
Registered
Joined
·
849 Posts
Bair dies are marked in 1000ths of an inch the same as Spolar and Pacific/Hornady. Use their data for a starting place, then weigh the charge.

Buz
 

·
Registered
Joined
·
3,311 Posts
Discussion Starter #3
I understand the powder bushing are marked in thousands and the shot bushing are marked as what they are, example 1-1-4 or 1-1-8.

The one I have a question about is marked - Bair/NO 6-5 1 6? I have never seen a Bair chart and I thought maybe they had some marked as PW does. With numbers meaning certain things instead of the actual measurement?

Thanks,
Ajax
 

·
Registered
Joined
·
3,311 Posts
Discussion Starter #4
This may be a better question. What is the inside diameter of a 3/4 oz bushing or bar?

Thanks,
Ajax
 

·
Registered
Joined
·
420 Posts
Hornady or pacific bushings are the same. I dont have a 3/4oz. to check but if you need a certain size, i can make you one. We have bosses at work with a 3/8 tapped hole in center all i do is drill the hole to larger size. They drop right in PW's,Pacific,Hornady,& the bair too. Keith
 
1 - 9 of 9 Posts
Status
Not open for further replies.
Top