Trapshooters Forum banner

Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
234 Posts
Discussion Starter #1
add on rib for new XT 32

I have a fairly new Browning 12, XT with a 32" barrel, I have raised the comb up and the gun shoots about 70/30 and shoots pretty good, but the rib sighting plane is on a slant now. but i have adjusted to shoot it that way. Does any one or some one make a add on rib adjustable to have a flat sight plane to look down instead of seeing a slanted rib? Hope this make sense?
 

·
Registered
Joined
·
587 Posts
add on rib for new XT 32

I have a model 12 that was stocked a little high for me,so I had Keensights make a 3/8 high rib at the same poi as before and just raised my adj. comb a bit.My head is now more level and see the target better and my scores are much steadier since I had it done,The workmanship is top notch.


joe
 

·
Registered
Joined
·
234 Posts
Discussion Starter #5
add on rib for new XT 32

Thanks for the comments, I called Keensights and talked to them. I now have to make a pattern to see what I need and get back to the with the size.

Hope what I give them will come out with what I need?
 

·
Registered
Joined
·
2,063 Posts
add on rib for new XT 32

Hey, Bill....if you want to see what it will look like, go to my website....the picture on the first page is an XT with a 1/2" high Keensights rib....

Ken Rucker
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top