Trapshooters Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
839 Posts
I have a couple and they retained a lot of plastic. I had to scrape it out. finally took some sticks of polish, 4 different grades, and that solved the problem.
Bill
 

·
Registered
Joined
·
636 Posts
I replaced all my Invector Plus tubes with AnglePort chokes.
On the pattern board there is all the difference in the world.
AnglePorts throw a very even pattern. The Brownings on the other
hand are all over the place.
Mike C.
 

·
Registered
Joined
·
13,624 Posts
I have a custom one that they made me for my Remington 1100 Stan Baker barrel. Matched the ID of the bore exactly to what I ordered, and the constriction to what I ordered. Pounds targets when I do my part.

Haven't shot much with the barrel/choke yet, but 125 rounds and not a breath of plastic buildup in either the barrel (which has a mirror finish from Baker) or the choke. Using 1 box of claybuster wads, and 4 boxes of Gun Clubs.

Where else can you go and get a custom cut choke for 50 bucks? Most everywhere else will charge you nearly 2x the price.
 
1 - 5 of 5 Posts
Top