Trapshooters Forum banner

A New Perazzi Model Engraved by the Incisioni Dassa Workshop.

2716 Views 17 Replies 15 Participants Last post by  The Canuck
A New Perazzi Model Engraved by the Incisioni Dassa Workshop.

You might have seen a black and white version of the second photo (below) on the artist's Instagram. There were a reasons for this: the work was not finished (see underside), and the new artwork had not been published by Perazzi.

Here – anywhere – and for the very first time, is the new Dassa-engraved in gold and enamels, non-sideplated Perazzi model.

(Mauro Dassa photos; Mauro Perazzi, auth. to publish.)

1744778
1744779
1 - 18 of 18 Posts

· Registered
Joined
·
94 Posts
The rooster on the black enameled perazzi looks great but I would be worried about chipping the black enamel finish. I like the Krieghoff done with the nickle finish with selected highlites on a gun that I would use for regular shooting.
Darrell
 

· Registered
Perazzi TMS/Browning Recoilless
Joined
·
1,654 Posts
I can do without the enamel. Makes it look like a one of those 80's cheapshit glued on DU emblems on dinner guns. That looks like Perazzi had the receiver finished at a turkish gun factory...
 
1 - 18 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top