Trapshooters Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
Conway here.

I am a new member and I found a thread on trapshooters while looking for info on cheddite primers.

The thread mentioned problems with shot getting stuck in the tube on some progressive loaders and falling thru late, causing all sorts of problems.

This was concerning 410 loads.

A solution to this problem has been found by a few people. Its simple.
Take a piece of brass rod, small diameter, that is small enough to fit into the drop tube lengthwise. Before you put it in give it a slight bend. A banana type bend. It acts as a baffle to let the shot trickle thru without
hanging up.

Anyway hope this helps.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top