Trapshooters Forum banner

Status
Not open for further replies.
1 - 12 of 12 Posts

·
Registered
Joined
·
273 Posts
Discussion Starter · #1 ·
there is a picture on the person's 366 loader that makes the big shot and powder bottles. it has a after market shouvel handle. does any one know who makes the shouvel handle for a 366 loader?
 

·
Registered
Joined
·
21,600 Posts
Try the site i provided above. They have them for $38.09. They also have the larger shot/powder bottles. Picture is from their site....Matt



 

·
Registered
Joined
·
273 Posts
Discussion Starter · #4 ·
what did you dis like about the shovle handles over the factory one? i have the shovle handles on my starr luber and dilion 550 press and love them.
 

·
Registered
Joined
·
21,600 Posts
I don't use one as i like the ball handle on mine. If your accustomed to using one on your other loaders it should be no big change for you.

Doggai just can't quit tinkering with his 366. LOL

Matt
 

·
Registered
Joined
·
575 Posts
I have and use the dogleg shovel handle on my 366 and really like it.

It puts most of the effort at the bottom of the stroke. Definately takes some stress off your shoulder.

There was a Jim that used to post on ts.com that I obtained mine from.
I put one on a PW loader also.
Would not go back to the factory handle.

ed.
 

·
Supporting Vendor
Joined
·
5,738 Posts
If your handle looks like this I made it. Jim Skeel





 

·
Registered
Joined
·
219 Posts
the one i had on my 366 was just like the one that matt shows here from basic design except mine was from DON BROWN if i remember right. razor
 

·
Registered
Joined
·
911 Posts
Jim: You make all kinds of littel doodads don't you?

I need to get busy as I only sell one doodad right now, and it's for a Jeep.

Diversity is the key to survival!

Randy
 
1 - 12 of 12 Posts
Status
Not open for further replies.
Top