Trapshooters Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
7,268 Posts
Yes , If it is an early one with the seprate gas check ring, it will have to be epoxied or migged in place. Been shooting one for over ten years that way. Jeff
 

·
Registered
Joined
·
25,277 Posts
The correct answer is.... maybe.<br>
<br>
Some barrels interchange successfully, yet on other guns the same model barrel will not work another receiver.<br>
<br>
The general rule of thumb is no, they will not interchange, but there are exceptions and they are on a one-by-one basis. And forends usually have to be swapped with the barrel, and this brings into play the forend cap retention system.<br>
<br>
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top