Trapshooters Forum banner

1100 remington deflector

1793 2
Need to know how to install a 1100 rem bbl stud,
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
21,601 Posts
This was covered here not long ago. If i remember correctly, a Tig Welder was the recommended welder choice. I believe it was also recommended that a professional do it. I learned they have to be tuned to a specific hull or group of hulls. Tron does this mod very resonable.
 

·
Registered
Joined
·
17,337 Posts
I recall examining one closely, and it looked like a separate piece. If that was the case it would have to be shrunk in, or inother words interference fit.

Used to do outer bearing races that way. Like the folks say, a spot of tig weld dressed up ;with a Dremel will suffice. Or a Nylok set screw.

HM
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top