Trapshooters Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
I use my 1100 for Sporting Clays. After about 30 round the trigger goes slack. The problem is the interceptor latch is getting stuck on the trigger group disconnecter.

Since I only shoot pairs in SC, can I just remove the interceptor latch and spring?

Thanks !
 

·
Registered
Joined
·
480 Posts
Yes, the interceptor can be removed then when you put the shell into the magazine it will come out on the lifter. Before removing try another trigger group to see if the problem continues.

Look closely at your trigger group and if the sear spring has been cut or replaced with one to light their might not be enough pressure for the disconnector to function.
 

·
Registered
Joined
·
111 Posts
The purpose of the interceptor latch is just as the name implies. It intercepts the second shell in the magazine tube and stops it from being released. It does not retain the round in the magazine. That is the job of the feed latch. If are only going the load one round in the magazine the interceptor latch can be removed.
 
1 - 3 of 3 Posts
Top