Trapshooters Forum banner

11-87 PROBLEM, NEED HELP

2636 11
Once shell is chambered, it is sometimes very difficult to unload the gun. The shell seems to get stuck in the chamber not allowing the bolt to be cycled. I'm using new estate shells. Does anyone know if it is possible and how one could polish the chamber so that the shells don't get stuck? The gun fires and cycles fine. Problem only exists when trying to unload manually. I had a previous post on the matter and appreciate all the advice and have found this to be the problem. Thanks, Jason
Status
Not open for further replies.
1 - 1 of 1 Posts

· Registered
Joined
·
6,754 Posts
Take the barrel off and drop a loaded shell into the chamber. It should go in freely and drop out the same. If it does then forget about the chamber and go to the locking mechanism on the bolt. Make sure the bolt handle slides freely in the slot on the bolt and when you pull it to the rear the locking bolt dros down. If this is not happening then look for grit between the locking botl and the bolt body.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top