Trapshooters Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Gunsmithing
    I am looking into "building" a Rem 1100 trap gun, any recommendations on a stock and barrel to use?
  2. Gunsmithing
    I nead front bead replaced on my ljutic on cape cod thank you
  3. Gunsmithing
    the plate that holds my adjustable comb on my browning XT has broke. The company that made the plate has went out of business so I can’t order another. Should I just buy a new stock or have a gunsmith put a new system in?
  4. Gunsmithing
    Ideally they could work on shotguns and other stuff as well. I have tried a few that I dont feel good about.
  5. Gunsmithing
    I have a 1954 Superposed Gr lV which I have shot a lot over the years. Recently, while shooting at the range I find the gun difficult to break open. This started after I had the hinge pin replaced and was wondering if it could be the firing pins are holding in the primer. The gun opens fine...
  6. Shooting Related Discussions
    Hi All, I've got a Beretta 682 X trap combo that needs a little attention. Top single barrels have quite a bit of play when the action is closed. O/U barrels are much better, but also much newer than the rest of the gun (and I'm not much of a doubles shooter....) So I dropped into my local...
1-6 of 6 Results