How do you change combination on Browning case
Steve12
1 - 10 of 10 Posts
Joined
·
442 Posts
Try pushing and holding the release button in the opposite direction of "open" and turn the dials to your code of choice.
Joined
·
260 Posts
There could be 2 ways.
Either put your combination to the correct numbers and slide the button to the opposite of open, change your combination and let go.
Or, there may be a silver or gold tab inside that you can either pull out or push in, slide left or slide right, do whichever one it is then set your combo, put the button/pin back and your done.
When all else fails there is YouTube.
Either put your combination to the correct numbers and slide the button to the opposite of open, change your combination and let go.
Or, there may be a silver or gold tab inside that you can either pull out or push in, slide left or slide right, do whichever one it is then set your combo, put the button/pin back and your done.
When all else fails there is YouTube.
Joined
·
442 Posts
... unless there's a small lever/button directly behind the combination dials inside the case, which you'd turn while resetting the dials.
Joined
·
442 Posts
Joined
·
442 Posts
If you squint while reading both rallen's post and mine, "What could possibly go wrong?"
Joined
·
260 Posts
Don't be - most "lower end" cases, factory beretta/browning, etc. are the push to the side type. My Nasco and Anericase my Kgun are in are the button behind type - very easy to do once you figure it out.
Joined
·
10,220 Posts
Thanks
1 - 10 of 10 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
