Trapshooters Forum banner
1 - 11 of 11 Posts

merek

· Registered
Joined
·
17 Posts
Discussion starter · #1 ·
I recently had an adjustable butt pad installed on my XT, and a new pad installed. I have never had recoil problems in the past, but all of the sudden I am having a lot of pain due to recoil. The pad installed just says "XLT" on it, I'm not sure if that's a brand or a size.

I'm not really sure what the issue is -- a few possibilities that have been mentioned to me are:
1.) the pad is too hard
2.) the pad cut is bad (it has a kind of "tail" towards the bottom)
3.) It's not far enough left

It feels as if the pain is at the bottom of my collarbone. I'm not sure if maybe I am holding the gun too high now? If I swap pads, is there a big difference between something like a Kick-eez and a more generic pad? What about shape? I am willing to replace the pad again, but just want to find the problem...the only other option seems to be to remove the adjuster, and install the original pad back.


Thanks!
 
Here we go. Merck first of all the person who installed the adjuster did not set it up to fit you. Everyone cab make assumptions but it's up to you to adjust it so it fits you. A simple way to make it fit is loosen the screws and close your eyes and put the gun into your shoulder until you're comfortable. Then open your eyes and see how much you need to move the gun to get it vertical without moving the pad at all. Once you have that set bring it up again and look in the mirror and see if the top of the pad is in full contact with your shoulder with your head in a comfortable position, if it is too high lower it. If you shoot trap curved pad, skeet and sporting flat pad. Adjust it properly and you will feel better. Joe
 
I agree partially with the above comment(s).

Some questions:

Gun mount - where is the top of the recoil pad relative to your collarbone - under it, on top of it?

How tall are you?

Pitch - Slowly mount your gun using your normal shooting posture. When you bring the gun back to your shoulder, does the whole pad, top to bottom, make simultaneous contact with your shoulder or does the bottom, pointed "toe" of the pad make contact before the top "heel" of the pad?

(The apparent protruding toe of the pad may be part of the problem. That is why I recommend flat recoil pads for most shooting disciplines.)

Are you mounting the gun in your "shoulder pocket," which is the indentation inside of your shoulder joint? This is where the recoil pad should make contact with your shoulder.

The question about your height will suggest why you had a pad adjuster mounted on your gun in the first place. (Shooters' expectations about the benefits of a pad adjuster are not always correct.)

Please describe in as much detail as possible the objectionable recoil you are experiencing.

And please answer all my questions.
 
Discussion starter · #7 ·
Gun mount - where is the top of the recoil pad relative to your collarbone - under it, on top of it?
- it seems to be at about the bottom of my collarbone.

How tall are you?
- 6ft 1

Pitch - Slowly mount your gun using your normal shooting posture. When you bring the gun back to your shoulder, does the whole pad, top to bottom, make simultaneous contact with your shoulder or does the bottom, pointed "toe" of the pad make contact before the top "heel" of the pad?
- After doing it slowly, the toe seems to hit first, and then the rest of the pad hits as I pull the gun tighter to the shoulder.

(The apparent protruding toe of the pad may be part of the problem. That is why I recommend flat recoil pads for most shooting disciplines.)
-- Is there an advantage over a straight pad vs other styles? Specifically, a rocker style was mentioned.


Are you mounting the gun in your "shoulder pocket," which is the indentation inside of your shoulder joint? This is where the recoil pad should make contact with your shoulder.
- I believe so. I just lowered the pad even more to try and see if that will help, to try and take the pad farther from the collarbone.


The question about your height will suggest why you had a pad adjuster mounted on your gun in the first place. (Shooters' expectations about the benefits of a pad adjuster are not always correct.)
- The main reason I got it was because of an inconsistent mount. I would kind of wiggle the gun to try and get it lined up. It does seem to better line up the beads when I mount.


Please describe in as much detail as possible the objectionable recoil you are experiencing.
- I think the pain is coming from hitting my collarbone. It's sore, and then it gets pretty painful after it hitting the same spot every time.
 
I could not get the quote feature to work the way I wanted so I improvised with quotation marks around original text and replied is caps.

"Gun mount - where is the top of the recoil pad relative to your collarbone - under it, on top of it?
- it seems to be at about the bottom of my collarbone."
PUTTING THE RECOIL PAD JUST UNDER YOUR COLLARBONE IS PARTIAL CAUSE OF THE RECOIL PROBLEM. IN ADDITION, THE PROTRUDING TOE OF THE RECOIL PAD IS MAKING THE GUN PIVOT UP DURING RECOIL AND THAT DRIVES THE TECOIL PAD INTO YOUR COLLARBONE.

I SUGGEST YOU GET RID OF THAT RECOIL PAD AND GET A FLAT PAD. LIMBSAVER AND KICK-EEX MAKE SOME OF THE BEST ONES.

OTHER MEMBERS MAY BE ABLE TO SUGGEST A SOFT PAD IF YOU SHOOT WITHOUT WEARING A SHOOTING VEST THAT PROTECTS THE COLLARBONE.

RECOIL IS BAD, EVERY BIT OF IT. FOR THAT REASON, I STRONGLY RECOMMEND A SHOOTING VEST, IDEALLY ONE WITH AN INNER SORBOTHANE PAD IN THE SHOULDER AREA.

GIVEN YOUR HEIGHT COUPLED WITH YOUR RATHER LOW GUN MOUNT, YOU PROBABLY NEED TO LEAN YOUR NECK FORWARD WHEN YOU PUT YOUR CHEEK ON THE COMB. WITH A FLAT RECOIL PAD, YOU WOULD BE ABLE TO MOUNTI YOUR GUN WITH CLOSE TO AN INCH OF THE RECOIL PAD EXTENDING ABOVE YOUR COLLARBONE. (OF COURSE, YOU WILL NEED A SHOOTING VEST TO PROTECT YOUR COLLARBONE.

RAISING YOUR GUN MOUNT WOULD ALLOW YOU TO SHOOT WITHOUT HAVING TO LEAN YOUR NECK FORWARE, IT WILL ALSO ALLOW YOU TO SEE TARGEETW WITHOUT LOOKINE "UP" - WITH THE PUPILS OF YOUR EYES IN THE CENETRS OF THERI SOCKETS.

"Pitch - Slowly mount your gun using your normal shooting posture. When you bring the gun back to your shoulder, does the whole pad, top to bottom, make simultaneous contact with your shoulder or does the bottom, pointed "toe" of the pad make contact before the top "heel" of the pad?
- After doing it slowly, the toe seems to hit first, and then the rest of the pad hits as I pull the gun tighter to the shoulder."

THE PITCH ON THE STOCK IS WRONG FOR YOU, MADE WORSE BY THE SHAPE OF THE PAD BEING SLIGHTLY CONCAVE THE PROTRUDING TOE.

" (The apparent protruding toe of the pad may be part of the problem. That is why I recommend flat recoil pads for most shooting disciplines.)
-- Is there an advantage over a straight pad vs other styles? Specifically, a rocker style was mentioned."

A ROCKER PAD WOULD SNUGGLE INTO YOUR SHOULDER POCKET BETTER THAN THE PAD YOU HAVE BUT YOU WILL STILL NEED TO LEAN YOUR NECK FORWARD TO MOUNT THE GUN BECAUSE YOU COULD NOT RAISE YOUR GUN MOUNT LIKE I DESCRIBED ABOVE. (GENERALLY, I DON'T LIKE ROCKER PADS VERY MUCH.)

"Are you mounting the gun in your "shoulder pocket," which is the indentation inside of your shoulder joint? This is where the recoil pad should make contact with your shoulder.
- I believe so. I just lowered the pad even more to try and see if that will help, to try and take the pad farther from the collarbone."

THAT WILL SPARE YOUR COLLARBONE FROM FURTHER PAIN BUT IT IS TREATING A SYMPTOM AND IGNORING THE CAUSE. IN DOING SO, YOU WILL HAVE TO LEAN YOUR NECK EVEN FURTHER FORWARD AND IN SO DOING, DECREASE THE DISTANCE BETWEEN YOU NOSE AND YOUR TRIGGER HAND THUMB, WHICH SOULD BE NO MORE THAN 1.5" AND WITH A CONSISTENG GUN MOUNT A 1" SEPARATION OR EVEN A LITTLE LESS WOULD BE OK.

THE REASON YOU ARE HAVING DIFFICULTY DEVELOPING A CONSISTENT GUN MOUNT IS THAT AWRUL TOE PROTRUDING RECOIL PAD. A SLIGHTLY LONGER NECK THAT THE STOCK DESIGNER HAD IN MIND WHEN HE DEWIGNED THE STOCK (SPECIFICALLY, WHAT IS KNOWN AS THE "DROP AT THE HEEK" STOCK DIMENSION, WHICH DESCRIBES THE DISTANCE FROM THE TOP OF THE RECOIL PAD (THE HEEL) TO THE LEVEL OF THE RIB.

THAT DISTANCE COUPLED WITH A SHOOTERS HEIGHT/NECKLENGTH AND THE HEIGHT OF THE GUN MOUNT DETERMINES HOW NATURAL THE HEAD AND NECK POSUTURE WILL BE WHEN SHOOTING. IT DETERMINES THE QUALITY OF THE GUN MOUNT IS AND AIDS IN KEEPING THE EYE ALIGNED WITH THE RIB DURING SWINGS TO TARGETS. (WHEN THE EYE MOVES RELATIVE TO THE RIB DURINS A SWING, THE PATTERN ALSO MOVES IN THE SAME DIRECTION.

VERY LITTLE EYE MOVEMENT REELATIVE TO THE RIB IS REQUIRED TO MOVE THE CORE OF THE PATTERN, (WHICH ASSURES A TARGET BREAK) OFF THE TARGET TO THE FRINGE OF THE PATTERN, WHICH IS A "SOMETIMES" BREAK.
KEEPING THE HEAD STATIONARY RELATIVE TO THE RIB IS VERY IMPORTANT. IT IS AIDED BY A GUN THAT FITS AND A GOOD SHOOTING FORM, PARTICULARLY A GOOD, CONSISTENT GUN MOUNT.

WITH A FLAT RECOIL PAD AND WITH MOUNTING PRACTICE, YOU WILL DEVELOPE A CONSISTENT GUN MOUNT.
10 OR 15 PRACTICE GUN MOUNTS A DAY WITH AN EMPTY GUN, WEARING THE SAME CLOTHES AS YOU WEAR WHEN YOU SHOOT FOR A COUPLE OF WEEKS SHOULD ALLOW YOU TO DEVELOPE A CONSISTENT MOUNT.

IT'S BORING, A LITTLE TIRING, INCONVENIENT, BUT IT IS VERY IMPORTANT!
 
Discussion starter · #9 ·
Rollin, thanks a lot. I'm going to drop the gun off at the gunsmith, and ask for a flat Kick-Eez installed. I think I should be able to go back to comfortably shooting without a vest...my gun is heavy at about 9lb. I don't believe I have an issue with not leaning far enough forward -- my nose tends to be about an inch or two away from my thumb (and the front of the comb)....I recently took a Nora Ross class, and that wasn't mentioned to be a problem.

For the record, I set the pad all the way down, and it still was not right -- it only took one shot to learn that.
 
With the neck leaning issue I commented on above, I forgot that you had a pad adjuster and had lowered your recoil pad.

The issue would involve leaning your neck forward. It is something that is best avoided, which lowering your recoil pad addresses.

Lowering the pad will however, increase barrel rise during recoil, especially with a recoil pad that has the toe protruding because during recoil, the gun pivots upward on some portion of the recoil pad. The farther that portion is below the barrel axis, the greater the barrel rise will be.
 
I also have the XLT, it's made by pachmayr, it's super soft.. It is concave but it fits into my shoulder pocket perfectly. I shoot the Browning BT 99 PLus. No recoil at all, because it's a heavy gun.. It might just be the adjustable pad. I had one installed on my Rem 1100 classic trap, and never used it. I could never get it set to a comfortable position.. HAving the BT99 plus with the high rib helps me with my sight picture .
 
1 - 11 of 11 Posts