1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

WTS: Keensights add-on ribs

Discussion in 'Uncategorized Threads' started by fritzi93, May 8, 2007.

Thread Status:
Not open for further replies.
  1. fritzi93

    fritzi93 TS Member

    Joined:
    Jan 29, 1998
    Messages:
    321
    Got ribs off a K-80 combo 32/34. Both 3/4 inch high, grooved ribs with 4 fiber optics, front bead screws assortment, RTV, etc. No change in POI. $150/ea. or $250 for both. I pay shipping/insurance, sent upon receipt of bank check or money order. (Remove the Zs front and back of email addy above.)

    One is 29 1/2 inches long, with mid bead recess at 18 7/8 inches from muzzle. Other one is 31 5/8 inches long, mid-bead recess at 16 1/16 inches from muzzle. But anyone with a Dremel or similar can make a small hollow so it's not necessary to remove your mid-bead.

    The front bead hole is a standard 1/4 inch from the muzzle. Select the correct screw, apply RTV to rib, attach at front bead hole, apply even pressure along the length for a couple of minutes and it's set. It really stays on, but not too difficult to remove with the supplied cord. Original instructions included.

    As can be seen in the picture, there's extra meat at the rear if one wants to shorten the rib, or to change the angle. These ribs were purchased in December last year, not used much, good shape, a couple nicks in the epoxy black paint.

    <a href="http://www.picvault.info/images/537043610_P5080011.jpg" target="_blank">[​IMG]</a>
     
  2. fritzi93

    fritzi93 TS Member

    Joined:
    Jan 29, 1998
    Messages:
    321
    Sold, pending receipt of payment.
     
Thread Status:
Not open for further replies.