1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Wanted ; Perazzi Ejector

Discussion in 'Uncategorized Threads' started by lytnin1, Oct 22, 2007.

Thread Status:
Not open for further replies.
  1. lytnin1

    lytnin1 Member

    Joined:
    Feb 15, 2007
    Messages:
    131
    Location:
    Forest Hill New South Wales, Australia
    I need a R/H [ bottom barrel] ejector for an early [1967] TYPE 1 [MX8} Perazzi.
    Can any shooter help and give me some ideas ?? S/No is 30912.
     
  2. lytnin1

    lytnin1 Member

    Joined:
    Feb 15, 2007
    Messages:
    131
    Location:
    Forest Hill New South Wales, Australia
    Thanks for your help guys, has Giacomo got an email address as I am in Australia
     
  3. lytnin1

    lytnin1 Member

    Joined:
    Feb 15, 2007
    Messages:
    131
    Location:
    Forest Hill New South Wales, Australia
    Thanks Steve I will, straight away
     
  4. Jerry944t

    Jerry944t Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,860
    Location:
    PA
    You can get all his info from the website I included.
     
  5. lytnin1

    lytnin1 Member

    Joined:
    Feb 15, 2007
    Messages:
    131
    Location:
    Forest Hill New South Wales, Australia
    SteveW this email address is non existant [ LeeMdsw1@aol.com}
     
  6. lytnin1

    lytnin1 Member

    Joined:
    Feb 15, 2007
    Messages:
    131
    Location:
    Forest Hill New South Wales, Australia
    Thanks guys ---- still trying to get thru to Giacomo Regards Charlie
     
  7. whiz white

    whiz white Strong Supporter of Trapshooting Banned

    Joined:
    Jan 29, 1998
    Messages:
    4,771
    Location:
    Rapid City SD
    It will have to be fitted (most are over-sized) and should be fitted by a Perazzi repair person, or someone familiar with Perazzis.

    I'm not sure Lee is the person to contact for parts. You need to call/email Giacomo in NY.

    Perazzi uses a bit different rim cutter which is VERY important beaus a typical cutter can cause an elongation in the chamber when cutting the shell rim, if not done in a lathe. The cutter cuts BOTH the correct chamber contour and correct rim depth.

    I have Clymer make me their Perazzi cutter with spring loaded sized bushing adapters for the chamber. I think I paid $250 for it 20 years ago.

    You may try his fax number as well: 315-336-0260

    Whiz
     
Thread Status:
Not open for further replies.