1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

To MEC 9000 owners.

Discussion in 'Uncategorized Threads' started by ansvel, Apr 29, 2008.

Thread Status:
Not open for further replies.
  1. ansvel

    ansvel Member

    Joined:
    Jan 29, 1998
    Messages:
    168
    When I move the handle down, it goes to the end well and smooth. On a way up, it goes half way good, then stuck and I should force a bit to bring the handle in upper position.
    Is this normal? If not where should I look to fix or/and lubricate?
    Thanks.
     
  2. Trap2

    Trap2 Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,685
    Location:
    Redding, California
    A certain amount of pressure on the upward stroke is normal for a 9000G. The upward stroke is the movement that rotates the shell from one station to another. Just make sure the loader is lubricated per Mec's instructions. If you don't have a manual, one is available to download on MEC's website..... Dan Thome (Trap2)
     
  3. FLAKETM

    FLAKETM TS Member

    Joined:
    Jan 29, 1998
    Messages:
    458
    You're getting good advice but you should also try the watts line number on your MEC instruction booklet. They have some great techs, who will walk you through just about anything.
     
  4. Quack Shot

    Quack Shot Active Member

    Joined:
    Mar 14, 2006
    Messages:
    4,003
    Clean and lube the collet (anti-seize) and make sure you lube the rest of the lubrication points with the MEC specified grease/oils. It sounds as though the collet is dry.
     
Thread Status:
Not open for further replies.