1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

TM1 Firing pin

Discussion in 'Shooting Related Threads' started by Danny56, Mar 8, 2010.

Thread Status:
Not open for further replies.
  1. Danny56

    Danny56 TS Member

    Joined:
    Feb 4, 2006
    Messages:
    295
    Anyone have instructions on how to remove a firing pin on an Ithaca TM1. I did a search and didn't find much. Any help would be appreciated. Thx.
     
  2. TOOLMAKER 251

    TOOLMAKER 251 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    3,398
    Remove trigger assembly, remove stock. You will see a cross pin going through the receiver where the front of the stock fits in. Push this pin out and you can take out the pin and spring.
     
  3. Danny56

    Danny56 TS Member

    Joined:
    Feb 4, 2006
    Messages:
    295
    Thank you. The Top pin is for the firing pin. I removed it and changed it. What is the bottom pin for? While I am in this far I might as well take it all apart for a good cleaning. There is a slot screw just below and to the right of the two pins will this release the locking bolt? Thx.
     
  4. PerazziBigBore

    PerazziBigBore TS Member

    Joined:
    Jan 29, 1998
    Messages:
    3,859
    That is NOT a screw.. You push it in.. so the top lever can be removed from the top... The slot is for indexing only..
     
Thread Status:
Not open for further replies.