1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

? Tightening trigger guard on a TM1

Discussion in 'Shooting Related Threads' started by leftex, Sep 22, 2012.

Thread Status:
Not open for further replies.
  1. leftex

    leftex Active Member

    Joined:
    Jan 29, 1998
    Messages:
    1,172
    Location:
    South of Dallas
    The guard on my TM1 trigger is a little loose. What is the correct way to tighten it?

    Thanks,
    Wayne
     
  2. B.C.

    B.C. Member

    Joined:
    Jan 29, 1998
    Messages:
    843
    put a piece of lead shot in the hole and tighten the guard !
     
  3. shot410ga

    shot410ga Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    7,784
    A little steel wool in the hole and tighten.
     
  4. Avaldes

    Avaldes Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,876
    Location:
    Central Coast of California
    Not that I am experienced with this problem, but the two posts above are basically saying to put something into the threads to keep the guard from wobbling. The first issue is that the wobbling is a symptom. So you may need to have something repaired by a good Perazzi mechanic. But if not, perhaps a wrap of telfon tape? At least it is inert and won't introduce rust to the equation.
     
  5. whiz white

    whiz white Strong Supporter of Trapshooting Banned

    Joined:
    Jan 29, 1998
    Messages:
    4,771
    Location:
    Rapid City SD
    Loose how? Front-to-back, side-to-side?

    If it's in the rear hole area of the trigger housing, perhaps a new 5107 [shown below as a 107 -Trigger Lock Plate] pin may solve the problem.


    whizwhite_2008_0203295.jpg


    WW
     
Thread Status:
Not open for further replies.