1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Tecumseh engine help

Discussion in 'Off Topic Threads' started by slipping into darkness, Feb 15, 2011.

Thread Status:
Not open for further replies.
  1. slipping into darkness

    slipping into darkness TS Member

    Joined:
    Mar 5, 2008
    Messages:
    403
    Have another question, am assembling engine, got values back in and timing marks line up to the crank was going to put cover on and on the cover is another small plastic gear that goes on the other side of the crank gear,is that got to line up to anything??????? and what is it. THANKS AGAIN FOR ALL THE HELP.
     
  2. BeerKing

    BeerKing Active Member

    Joined:
    Jan 29, 1998
    Messages:
    1,203
    Call this number, his name is Bob 319-389-5753
     
  3. Shooting Jack

    Shooting Jack Active Member

    Joined:
    Jul 29, 2006
    Messages:
    3,523
    Location:
    Blackshear, Georgia
    If it's the oil slinger(for lack of a better work) you don't have to line anything up. Does that engine have a governor. Some have the oil slinger as part of the governor. Jackie B.
     
  4. Ka9bce

    Ka9bce TS Member

    Joined:
    Sep 3, 2009
    Messages:
    13
    No the plastic gear only runs the governor counter weight, hope this helps.... Paul
     
  5. ricks1

    ricks1 TS Member

    Joined:
    May 7, 2007
    Messages:
    1,545
    dont matter where it sits but do replace shaft key even if it looks good
     
  6. slipping into darkness

    slipping into darkness TS Member

    Joined:
    Mar 5, 2008
    Messages:
    403
    Thanks everyone, it is a governor & oil slinger combine, up and running.
     
Thread Status:
Not open for further replies.