1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

SX1 Rubber O-Rings

Discussion in 'Shooting Related Threads' started by b12, Jan 25, 2009.

Thread Status:
Not open for further replies.
  1. b12

    b12 Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,049
    The rubber o-ring that goes over the tube looks like their should be two of them one under and one over that steel ring. Is this right or wrong. I don't have any drawing that shows me. I figured this is the best place to find out. B12
     
  2. Dove Commander

    Dove Commander TS Member

    Joined:
    Feb 21, 2007
    Messages:
    1,364
    (1) O ring, not 2.
     
  3. b12

    b12 Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    3,049
    Thanks B12
     
  4. Baron23

    Baron23 Well-Known Member

    Joined:
    Jan 21, 2006
    Messages:
    1,632
    The metal ring is concave on both sides in the later editions which might give you the impression that there should be a o-ring on both sides. Earlier metal rings only had the depression to accomodate seating an o-ring on one side....but people would put the ring on backwards or forget which way it went. Probably saved a lot of customer service calls to make the metal ring symetrical.
     
Thread Status:
Not open for further replies.