1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Stuck ejector on sub gauge tubes

Discussion in 'Shooting Related Threads' started by hmb, Nov 25, 2011.

Thread Status:
Not open for further replies.
  1. hmb

    hmb Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    9,613
    Did you lube them? Do they move? HMB
     
  2. mag410

    mag410 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    856
    Location:
    NE Mississippi
    Remove the extractors from the tubes and do a little cleaning and polishing.

    The extractors are easier to remove than to re assemble. There is a bevel on each edge of the extractor and it takes a bit of practice to get them to pop back into place. A bit of jeweler's rouge or very fine lapping compound on the tip of a pencil eraser will smooth things right up.

    Michael Goines
     
  3. Pull & Mark

    Pull & Mark Well-Known Member

    Joined:
    Mar 9, 2006
    Messages:
    5,561
    Call the sales rep. at Briley or Kolar and see how they want to handle it!!! Tell him whats going on and let them make the call. If you have to pay for the shipping its better to do it now than wait and have to repair your ejectors as well if let it go to long. Good Luck and break em all Jeff
     
Thread Status:
Not open for further replies.