1. We have added the ability for anyone to 'bump' threads that they have created. This is mainly useful in the classifieds area where posters constantly bump for sale threads to bring it to the top. This allows them the ability to do that without having to clutter the thread with extra 'TTT' and 'Bump' type posts. To bump it, go inside your thread and click on 'Thread Tools' at the top, then select 'bump'. You can bump only once per 24 hour period.

    For more detailed information please see this post: Thread Bump Functionality.
    Dismiss Notice
  2. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

SOLD Perazzi MX Trap Stock for High Rib & Long LOP

Discussion in 'For Sale- Members only' started by ltctpu, Sep 15, 2012.

Thread Status:
Not open for further replies.
  1. ltctpu

    ltctpu Member

    Rating - 100%
    5   0   0

    Joined:
    Jan 29, 1998
    Messages:
    390
    Location:
    Missouri City TEXAS
    SOLD Perazzi MX Trap Stock for a drop out trigger series. Set up for a High Rib and extra-long Length of Pull.


    Caveat to the measurements are: Once I figured out that this is too straight of a stock for my set up, I was not very inspired to remove my G-Squared unit for more exacting detail. So they based on carefully overlaying this stock on my MX8 Flat rib Sporter and prudently aligning the stock to the rear of the receiver to determine LOP and Drop… I’d say they are pretty darn close but not as exact as if mounted.


    Drop at comb and heal is 3/8” to 5/16” based off my flat rib barrel. LOP would is a long 16 3/8” the end of the wood without a pad. Length of the wood from the receiver side to end of the wood through the center is 18 9/16” (See tape measure Picture) Neutral cast based that the bolt hole is pretty much on the center line.


    Nice Condition with a bit of a figure….. no cracks and some handling marks, there is one spot the left side it has a light scratch might polish out and a dent as shown in picture 5. Poly finish, if it were oil finished that dent would steam out I’m sure.


    Stock bolt included.


    $375 plus $15 shipping


    As always, no hassle refund if you’re not satisfied.


    Thanks for Looking!


    Regards


    Tom



    ltctpu_2008_0303519.jpg

    ltctpu_2008_0303520.jpg

    ltctpu_2008_0303521.jpg

    ltctpu_2008_0303522.jpg

    ltctpu_2008_0303523.jpg

    ltctpu_2008_0303524.jpg

    ltctpu_2008_0303525.jpg

    ltctpu_2008_0303526.jpg

    ltctpu_2008_0303527.jpg

    ltctpu_2008_0303528.jpg

    ltctpu_2008_0303529.jpg

    ltctpu_2008_0303530.jpg

    ltctpu_2008_0303531.jpg
     
  2. ltctpu

    ltctpu Member

    Rating - 100%
    5   0   0

    Joined:
    Jan 29, 1998
    Messages:
    390
    Location:
    Missouri City TEXAS
Thread Status:
Not open for further replies.