1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Shotgun Springs & Spring Kits

Discussion in 'Uncategorized Threads' started by Tron, Jun 13, 2008.

Thread Status:
Not open for further replies.
  1. Tron

    Tron Supporting Vendor Supporting Vendor

    Joined:
    Jan 29, 1998
    Messages:
    6,651
    The Perazzi boys must be turning you into a millionaire many, many times over.

    Tron
     
  2. JH

    JH Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    1,359
    Where have you been all these years?

    1. Need Winchester Super X-1 mainsprings for HEAVY use of 3 dram and 3 1/4 dram loads. There are some out there but we need a bit heavier springs than Stu Wright sells.

    2. Heavier mainsprings for Beretta 303s. Heavy use of 3 dram loads weaken the heck out of the mainsprings.

    You make em, I will buy them!
     
  3. Buster 25

    Buster 25 Member

    Joined:
    Apr 4, 2006
    Messages:
    315
    Morning Gent's
    You might check with MIDWAY Shooting Supply Co.
    They carry a line of "Wolf" spring, I found a hammer for my Ljutic there, Just below it they had listed "Leaf" Springs for Perazzi, and other's also.

    These "WOLF" springs are good one's I have them in my .45's and my M-1.
    The price is real right, the Spring for my Ljutic was $6.00 if I recall, It cost more then that too ship it.
    Worth looking into.
     
  4. bigbore613

    bigbore613 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    4,469
  5. bigbore613

    bigbore613 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    4,469
  6. decimamas 54

    decimamas 54 Active Member

    Joined:
    Feb 8, 2007
    Messages:
    872
    Location:
    ITALY
    To wjf100st
    We are the only Company that makes after market leaf springs for Perazzi guns and we give one year guarantee on its. We make spring tools in stainless steel or steel. We also make firing pins (two pieces construction).
    My website is www.gmgunparts.com
    Hope this helps you.
     
Thread Status:
Not open for further replies.