Trapshooters Forum banner
Status
Not open for further replies.

Riser legs for Hornady 366

2K views 10 replies 10 participants last post by  Bob Mason 
#1 ·
Does any one know if they still make the steel base riser legs for the Hornady 366?

Thanks in advance
Bob Mason
 
#4 ·
I needed mine to be about an inch higher...got a piece of 1x6 and mounted it through that.

Raised it just enough that it can move the whole machine forward on the table. You might not need to go as high as you think, if you have handle stroke problems.

You could always use two pieces of 1x6, too. Or even three....
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top