1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Repair help needed in the DFW area for a 870

Discussion in 'Uncategorized Threads' started by Lew, Jan 6, 2008.

Thread Status:
Not open for further replies.
  1. Lew

    Lew TS Member

    Joined:
    Jan 29, 1998
    Messages:
    70
    The feed rail came out of the channel and it looks like the staking failed on my 870 trap. Does anyone know a repair guy in the Dallas Fort Worth area. All help appreciated. Thanks
     
  2. Ruck

    Ruck Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    2,045
    I'm in Sadler ( 70 miles north of Dallas)....and I have a staking tool........

    Ken Rucker....Speedbump Stockworks
     
  3. Lew

    Lew TS Member

    Joined:
    Jan 29, 1998
    Messages:
    70
    I will try to give you a call tomorrow in the morning and we can set up a time to meet. Thanks.
     
  4. whiz white

    whiz white Strong Supporter of Trapshooting Banned

    Joined:
    Jan 29, 1998
    Messages:
    4,771
    Location:
    Rapid City SD
    Really, it will work fine without the staking. I have a staking too and do it for nothing for the folks here, but I'm a helluva ways north.

    You can put it back it and hold it in place with the smaller trigger pin,slide the trigger in, and using a wire (coat handger) hold the rear of the rail in while you slide the trigger in.

    Put in the two pins fully and away you go.

    Ken will do you a good job if you get up his way.

    Whiz
     
  5. loweight

    loweight Member

    Joined:
    Sep 20, 2007
    Messages:
    60
    Johnny Green is in Hurst off Harrison St.
     
  6. Lew

    Lew TS Member

    Joined:
    Jan 29, 1998
    Messages:
    70
    Ken, thanks again for the offer of help. I did manage to stake the part and I all went back together as new. thanks again.
     
Thread Status:
Not open for further replies.