1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Removing forend iron on perazzi

Discussion in 'Shooting Related Threads' started by doc boc, Jul 29, 2012.

Thread Status:
Not open for further replies.
  1. doc boc

    doc boc Member

    Joined:
    Jan 29, 1998
    Messages:
    414
    What is the proceedure for removing the forend iron from the forend of a type 4 perazzi. Also reassembly of same. Thanks doc
     
  2. Sky Buster

    Sky Buster Sky Buster TS Supporters

    Joined:
    Jan 29, 1998
    Messages:
    2,982
    Location:
    Minnesota
    DOC:
    Remove forend. Inside the iron you will see a small slotted screw.
    It is visable through the round hole in the iron. Loosen it and
    the plunger will come out. Then use your stock wrench to remove
    the inner retainer. After it's out, tap the iron with a plastic
    hammer and it's out.
     
  3. lightning20ga

    lightning20ga Member

    Joined:
    Apr 1, 2011
    Messages:
    820
    doc my mx8 has a allen in each hold the face that rides on ur receaver type4im not home but ck for srews else where the allens r metric take out all the way tap iron should fallout u will c retainer r comletly off allens
     
  4. JACK

    JACK Well-Known Member Supporting Vendor

    Joined:
    Apr 28, 2006
    Messages:
    14,742
    Location:
    NW Wisconsin
    Geez. At the end of the forend iron at the radius that fits into the receiver is 2 3mm hex bolts. Back those out completely. Remove and lay aside. Then grasp the iron and pull/wiggle the iron away from the forend wood. About 50% of the time it will not release.. If not, then grasp the forend wood with your dominate hand and smack the junction of iron wood several times into the palm of your other hand and on top and bottom. Usually now you will see a small space beginning to form between the iron and the wood. Wiggle again and most of the time it will come loose. Get it apart before we tell you how to reassemble.
     
  5. doc boc

    doc boc Member

    Joined:
    Jan 29, 1998
    Messages:
    414
    Does the removal "latch" come out together with the iron or does than drop out from the other side.
     
  6. JACK

    JACK Well-Known Member Supporting Vendor

    Joined:
    Apr 28, 2006
    Messages:
    14,742
    Location:
    NW Wisconsin
    The latch pops to the outside. Push it out with your fingers or my fave tool with the forend iron parts is an old plastic toothbush as a punch and my plastic hammer. Tap one end at a time.
     
  7. doc boc

    doc boc Member

    Joined:
    Jan 29, 1998
    Messages:
    414
    many thanks doc
     
  8. JACK

    JACK Well-Known Member Supporting Vendor

    Joined:
    Apr 28, 2006
    Messages:
    14,742
    Location:
    NW Wisconsin
    So Doc... How goes the procedure on your Perazzi Forend?
     
Thread Status:
Not open for further replies.
Search tags for this page

how to remove perazzi mx8 forend

,

removing forend iron from kolar