1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Rebuilding 1100 20ga / need some parts

Discussion in 'Uncategorized Threads' started by trw, May 27, 2007.

Thread Status:
Not open for further replies.
  1. trw

    trw Member

    Joined:
    Jan 29, 1998
    Messages:
    153
    The bolt is special to the 20's built on the 12 frames, so that part is specific and not interchangable. The other parts you mention are standard to the 12ga guns and will interchange. You can get the parts you are seeking used and at reasonable prices from Jeff Lee at Lee's Gun Parts. His phone# is 972-790-0773. He is only open on Tuesday~Thrusday [CST] & you will probably have to call several times to get through, but he is a fine guy and he should be able to help you out.

    While you are putting it together, if the small plunger that the 'fork' fits into is aluminum, replace it with a steel one before it has a chance to create a problem because it will sooner or later .. they bend.

    On your stock, you may want to post a want to trade note and see if someone out there does not need a full length stock for their growing youngster and make it easier on both of you. Too, there are some good super low recoil [as in almost none] 3/4oz 20 loads and that may be what you start if he is small or a bit gun shy.

    Hope this helps you out.
     
  2. bigbore613

    bigbore613 Active Member

    Joined:
    Jan 29, 1998
    Messages:
    4,469
    May have a new standard 20 bolt. Jeff
     
  3. jimbob

    jimbob TS Member

    Joined:
    Jan 29, 1998
    Messages:
    655
    Isn't the action bars different as well as the bolt??
     
Thread Status:
Not open for further replies.