1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

pw 2000 Primer Feed

Discussion in 'Uncategorized Threads' started by nipper, Mar 7, 2008.

Thread Status:
Not open for further replies.
  1. nipper

    nipper TS Member

    Joined:
    Dec 30, 2007
    Messages:
    1,502
    I am having a problem with the primer feed assembly,the set screw under the spring will not come out no matter what i have tried,even used a wrench for leverage and bent 2 allen wrenches. What gives---has anyone else ever had this hard of a time removing the set screw?? I wanted to clean it because it was sticking every once and again,i did clean it from the outside with a spray cleaner and it works great now.

    Bill
     
  2. JerryP

    JerryP Active Member

    Joined:
    Jan 29, 1998
    Messages:
    1,753
    may have been assembled with an impact wrench. Try smacking the end of the allen wrench with a hammer rather than using more leverage.
     
  3. whiz white

    whiz white Strong Supporter of Trapshooting Banned

    Joined:
    Jan 29, 1998
    Messages:
    4,771
    Location:
    Rapid City SD
    Drill it out - easy to do because the bit will be centered in the hex slot area, then use a small easy-out.

    I use the Brownell's Gunsmith bits, not Allen wrenches, that are extremely hard. But, you could break it off in the set screw.

    Chances are the seating ram has it held in place.

    Whiz
     
Thread Status:
Not open for further replies.