1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

perazzi trigger

Discussion in 'Shooting Related Threads' started by jamie65, May 1, 2013.

Thread Status:
Not open for further replies.
  1. jamie65

    jamie65 Member

    Joined:
    Aug 21, 2011
    Messages:
    572
    is there a best hammer position when removing and installing a mx-8 trigger ? cocked vs fired.
     
  2. jamie65

    jamie65 Member

    Joined:
    Aug 21, 2011
    Messages:
    572
  3. Steve W

    Steve W Well-Known Member

    Joined:
    Jan 29, 1998
    Messages:
    5,110
    Location:
    Los Angeles
    If your cocking bar is properly retracted, it doesn't matter if hammers are cocked or not.
     
  4. JACK

    JACK Well-Known Member Supporting Vendor

    Joined:
    Apr 28, 2006
    Messages:
    14,706
    Location:
    NW Wisconsin
    just make sureof two things. 1) that the pins are all flush, and 2) that the inertia block been pulled back and disengaged from the sear levers. Hammers, schmammers.
     
  5. jamie65

    jamie65 Member

    Joined:
    Aug 21, 2011
    Messages:
    572
    thanks for the comments guys.
     
  6. whiz white

    whiz white Strong Supporter of Trapshooting Banned

    Joined:
    Jan 29, 1998
    Messages:
    4,771
    Location:
    Rapid City SD
    If you are reinserting the trigger to store the gun, not good.

    It should be a habit at the end of the day's shooting to remove the trigger and release the hammers then reinsert to store uncocked.

    Saves on the springs, and give you the time to look the trigger over for any possible spring cracks.

    WW
     
Thread Status:
Not open for further replies.