1. Attention: We have put together a thread with tips and a tutorial video to help with using the new software. Please take a moment to check out the thread here: Trapshooters.com Tutorial & Help Video.
    Dismiss Notice

Perazzi Ejecter Info needed TMX

Discussion in 'Shooting Related Threads' started by KEYBEAR, Jul 11, 2010.

Thread Status:
Not open for further replies.
  1. KEYBEAR

    KEYBEAR Active Member

    Joined:
    Jan 29, 1998
    Messages:
    3,222
    I,m needing to remove the ejector and shorten the springs but don,t remember how to remove the ejecter ? A little help please .
     
  2. gnprts

    gnprts Member

    Joined:
    Jan 29, 1998
    Messages:
    133
    Hello Alf 99............. With the barrel off push the ejector all the way in and remove the round keeper which you will see on the side under the ejector. the keeper has a hole in it. I use a block of wood on a flat surface to hold the ejector in while removing the keeper.. A magnet may be handy to pull the keeper out with.
     
  3. Ed Y

    Ed Y TS Supporters TS Supporters

    Joined:
    Jan 29, 1998
    Messages:
    2,424
    Location:
    Warren New Jersey
    TM-X is the same as a TM-1. Push the ejector in until you can see a small access hole going through the side of it. Using a thin wire/paper clip, go through the ejector and depress the lock pin. With it depressed, the ejector should slide out. If you've done it before, it should come back to you. Be careful that you don't let the lock pin or it's spring get away on you as well as the ejector and it's springs. Guess how I know.

    Ed Yanchok
     
  4. KEYBEAR

    KEYBEAR Active Member

    Joined:
    Jan 29, 1998
    Messages:
    3,222
    GNPRTS & Ed Thank You got it out and cleaned up .

    I had a stroke last summer and don,t remember alot of things anymore like i did .
     
  5. KEYBEAR

    KEYBEAR Active Member

    Joined:
    Jan 29, 1998
    Messages:
    3,222
    Ed this is an all Stainless Release trigger built by Bowen (I think) . It works better then any Perazzi trigger I have ever used bar none . The story I have on this trigger is ten were built and this is #04 . It is as new and solid as a rock .
     
  6. Ed Y

    Ed Y TS Supporters TS Supporters

    Joined:
    Jan 29, 1998
    Messages:
    2,424
    Location:
    Warren New Jersey
    I too have a release trigger, completely built by Bruce, but mine is not stainless steel.

    Ed Yanchok
     
Thread Status:
Not open for further replies.